587,223 active members*
3,170 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > BobCad-Cam > Mach 2 Mill post for V23?

Thread: Mach 2 Mill post for V23?

Results 1 to 4 of 4
  1. 04-03-2010, 05:52 PM #1
    sansbury
    sansbury is offline Registered
    Join Date
    May 2007
    Posts
    1026

    Mach 2 Mill post for V23?

    Does anyone have a V23 post for Mach 2 mill? When I was using V22, the Mach2 post worked perfectly, I'm just looking for a replacement for that. My V23 install didn't give me any posts except a default one, and the Mach 3 post on BCC's website doesn't work for me.... thanks in advance!
    Reply With Quote Reply With Quote
  2. 04-03-2010, 09:40 PM #2
    BurrMan
    BurrMan is offline Ghost
    Join Date
    Dec 2008
    Posts
    4548
    Can you post your old mach post here?
    Reply With Quote Reply With Quote
  3. 04-04-2010, 05:18 PM #3
    sansbury
    sansbury is offline Registered
    Join Date
    May 2007
    Posts
    1026
    I may have spoken too soon. I went back and copied the V22 post into the V23 folder, restarted, and it looks like it's posting now. I will need to test it a bit more, but this is better than I was getting.
    Reply With Quote Reply With Quote
  4. 04-04-2010, 08:54 PM #4
    BurrMan
    BurrMan is offline Ghost
    Join Date
    Dec 2008
    Posts
    4548
    You may want to have some modifications to it for use with new functionality with V23.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. visuall mill wih mach 3
    By gertjan in forum Visual Mill
    Replies: 3
    Last Post: 03-07-2010, 09:55 AM
  2. Mach 2 Mach 3 Post Processor
    By IntarisiaQ4 in forum Australia, New Zealand Club House
    Replies: 0
    Last Post: 10-17-2009, 11:50 PM
  3. Mach issue with my mill
    By Rich05 in forum Mach Software (ArtSoft software)
    Replies: 3
    Last Post: 12-01-2008, 12:00 AM
  4. Confused: Mach Turn, Mach Mill, Mach 2/3 ?
    By CanSir in forum Mach Software (ArtSoft software)
    Replies: 5
    Last Post: 02-16-2007, 11:41 AM
  5. I need a Post for Mach 3 in Visual Mill
    By replicapro in forum Visual Mill
    Replies: 1
    Last Post: 07-14-2006, 03:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules