I have a used turret punch machine.
It's Amada Pega344 with Fanuc 6M model B controller.
It's trouble with many alarms because the mice attack the wire.
Pls help me Electrical diagram for me to connect wire.
Thank alot
I have a used turret punch machine.
It's Amada Pega344 with Fanuc 6M model B controller.
It's trouble with many alarms because the mice attack the wire.
Pls help me Electrical diagram for me to connect wire.
Thank alot
Hello, Sorry, but i cant to help you, my problem is some yours, my vendor go away with all information about it (the money too) and I cant to put it work.
I'll continue to seek. Thanks
what wires are cut / I have drawing for 6m control but it is for a wire edm
I have the drawings for the Pega 357 and 345 with the Fanuc 6 control
I am not sure how close the wiring will be to your machine.
Send me your email address if you want me to send them
Try contacting Amada directly, they have manuals for sale.
GP.
thank you
I need the electrical diagram of a beloved 344, or information you have, I think it should be similar to the 345.
Please if you have something you can send me [email protected]
thanks
hi there, i have a issue with a pega 357 (1990) could you send me a copy of the electrical drawings you have, the machine i'm working on should have the TCU (a) board, i have the drawings for the TCU (b) relay board but the machine i'm on has been fitted with the TCU (C) relay board. ahhhh nightmare!
many thanks
Paul
[email protected] .uk
Hellow, I have Wediemann W4560 model MURATA WARNERS SWASEY Co JAPAN CNC turret punch machine,Mfg date 1986. In this machine facing some electrical problem, I need wiring diagram of FUNUC 6M control panel. Requesting you to send us on this email [email protected].
By Veeresh
HI CNCDIAG
I need the electrical diagram and ladder diagram of amada pega 345 fanuc 6M, if you have it,
Please if you have something,can you send to me it.
thank you very much , my email :[email protected]
good bye
If anyone could pass along the drawings for the Pega 357 with Fanuc 6 control it would be greatly appreciated. I'm trying to locate a part number for what I believe is a Fanuc cable (20 pin Honda to 17 pin Cannon connector - both female), which connects Motor A06B-0616-B383-R to MotherBoard A16B-1000-0030/06C
Email: [email protected]
hi guys ,
are you still looking for support for your machines...?
let me know.
thanks.
[email protected]
Pretty please, with magic beans on, can you send it to me? I thought it was classified information!
hi cncdiag
can you please send me the electrical drawings for Pega 357 and 345 with ( Fanuc 6 m control )
[email protected]
thanks.
can you please send me the electrical drawings for Pega 357 and 345 with ( Fanuc 04pc control )
need the electrical diagram of pega357,
Please if you have something you can send [email protected]
thanks
hello, we would also need an electrical diagram for the pega 357. the voltage for the Solenoid valve for the hammer blow does not reach 24V. only reaches 11V. mail [email protected] thank you
can you send it for me [email protected]