[Scotter]

Building a Vertical CNC Mill and I would like some suggestions for a spindle and where I can purchase them?
Scott

[DICKEYBIRD]

Depends on how big you're planning to build but here are a couple options for a little feller:
https://littlemachineshop.com/produc...INDLE+ASSEMBLY
spindles

[Scotter]

Thanks for the links ... but i was looking more in the likes of a spindle like ones used on Tormachs. I am in the process of designing and building a maching the sie of say a PM932M/PM45m.

My design plan at present:
Cutting Size: ~300mm x ~450mm x ~350mm
Spindle Speed: 5k to 8k rpm if i can afford more i will do it! ... currently looking for this source.
Motor: AC Brushless for at least a 3HP or more ... need more information here still
Electronics:
Servo Drivers: Geco or Leadshine
Controller: WARP9 ESS or PMDX 424
Motor Controller: still shoping and doing research ... seem to like Adlee is a good choice ... but at moment just shoping
Axis: Linear Guides ... at moment still on hunt for whats best to use to give me accuracy and long lif.
Software: Mach4

Anyway this is what i am up to ... if anyone can help me on my path to proper sections i would sure appricate it.

Scott

[G59]

Thanks for the links ... but i was looking more in the likes of a spindle like ones used on Tormachs.

Go on Tormach site. They are cheap and readily available.