[Shop-Dog]

Hello,

Yesterday at the end of a drilling cycle of 88 holes, and after the last hole, the CNC threw an error 0008 (PLC error without description) I checked the Error manual and it indicates that this means that a [nonexistant "G" function has been programmed]. I used Fusion for the CAD/CAM, so this makes little sense to me. The issue now is that I am I am not able to reset the controller with a double push of the Esc key as would be normal. Even with a complete shut down including powering off the mains it restarts in the same condition.

Additionally, even with the feed rate set to zero, all axes are moving slowly when the servo button is active and will continue to jog until it hits an over run condition, or put in manual (servo off). Please see the image attached and if someone has any suggestions, please let me know. Link to video here:

https://www.dropbox.com/t/XkO8dIp0XjCMxOCx

Thanks,

Steve