I was wondering if anyone has a spare Dyna 2800 Escap 1.8 deg/step stepper motor they want to sell? :violin:
I was wondering if anyone has a spare Dyna 2800 Escap 1.8 deg/step stepper motor they want to sell? :violin:
What size is the motor? They are industry standard sizes and mostly interchangeable electronically as long as you get the correct current rating.
Matt
Any luck finding a replacement motor? I'm looking for one also, to put on my 4th axis.
Yes and no, if i want to fulfill a minimum order of 20 pieces I can have Portescape make them for me but that is obviously cost prohibitive.
Here is the email from the vendor if you find an alternative let me know.
Hello Jim,
I also tried calling and left you a voice mail. For p/n P582-508-B-11 (or -00) the factory has advised there is a 20 pc minimum and a 23-week leadtime. I know you only really needed 1 pc.
Do you still want them to quote with this order min and leadtime?
Kirstine Prado, Customer Service Representative
Minarik Automation & Control – A Kaman Company
4975 E Landon Dr | Anaheim, CA 92807
P: 714-696-3750 | F: 714-696-3760 | minarik.com | kamandirect.com
[email protected]
Have you tried calling DynaMachtronics?
Welcome to DYNA Mechtronics
You can touch our service staff by:
U.S.A:
Tel: (408) 452-1010
Fax: (408) 452-1099
Email: [email protected]
Post pictures of whatever you have, I'm sure there is an alternative you can just bolt on.
Guys
Almost all stepper motors are standard mechanical sizes. Nema 23, 34 etc. In each mechanical frame size, there are a plethora of standard wiring configurations, torque ratings, etc. There is no reason you need the exact same motor. A similar motor will perform equally well.
For example: Lin Engineering - Step Motor Specialists
I am sure you could call and get some help on which motor would work best for you.
Matt
Yes I called Dynamechtronics, out of stock item.
Found this reply on another forum, someone asking the same machine, same question:
"Try to look for Vexta stepping motor from oriental motor.Model number:
PK 296-01A 2.2 ohm 2A."
I have a dyna myte 2400 will that work . I'm unsure what Im Doing with the cnc but I know I'm not keeping the stock steppers. I only have 2 of 3 axis .