[scbron]

I have one of the original Tracker cnc tables. The program begins properly, the steppers move correctly, but the torch no longer fires. Usually this means the relay has burnt out. In the past I would replace the relay and I would be back up and running again. Not so now. I am not an electronics person. My ideal would be to find the source for the control board and buy a new one while I have the old one sent out for someone to figure out what is wrong. Anybody have a schematic for the controller board or know where i can get a replacement.

Thanks,

[Torchhead]

Have you tried contacting Tracker?

[scbron]

yes, they no longer use this board and do not have replacement parts for it. Justin is being helpful but there are no schematics available so I am a little bit in the dark.

[kkustomz]

I know this is a old thread.... I have been keeping a old pre millineum table going for the last two years, Justin is very helpful and I have a local guy that helps me with the electrical trouble shooting. There is not alot of info out there on the old tables but they work very well when u can keep them going. I would like to keep in touch with anyone that has one and share problems issues and fixes between us.

Thanks, Keith Kubosh
[email protected]