Located in Houston, TX (77092)
This was in a makerspace in Houston and purchased in 2019. I worked on it, running wiring and replaced the laser power supply, but never cut/ engraved anything. It's been sitting in my garage since then with no additional work done.
It's also listed on marketplace in Houston, TX. Several Pictures can be found on that listing.
https://www.facebook.com/marketplace...85825423479410
Metal Stand and top cover included
Computer (exposed motherboard), Keyboard with Mach3 included
New Power Supply (only used to pulse the laser a few times)
Using archive.org, the original buildyourcnc page can be accessed.
https://web.archive.org/web/20181114...dEngraver.aspx
Lots of assembly and setup information in Warren Bailey's build documentation:
blackTooth DIY Laser Cutter Engraver Assembly from buildyourcnc.com: Index for blackTooth Laser Cutter/Engraver Build Project