587,396 active members*
3,770 visitors online*
Register for free
Login

Thread: Stepper Driver Alarm light

Results 1 to 3 of 3
  1. 12-09-2010, 04:44 AM #1
    DJR
    DJR is offline Registered
    Join Date
    Dec 2010
    Posts
    0

    Stepper Driver Alarm light

    Hi one of my stepper drivers has stopped working , there is two lights a red and a green . Both of them are on . Which is not supposed to be , the 2 others drivers only have the green light on. It is not due to overheating since it goes on right when i power it up after siting for a day. Anybody would have a solution ??

    Thank you
    Reply With Quote Reply With Quote
  2. 12-09-2010, 05:01 AM #2
    cjdavis618
    cjdavis618 is offline Registered
    Join Date
    May 2007
    Posts
    715
    I had the same issue with my Gecko 203V driver and it turned out that a bad batch of plugs had caused a loose connection and actualy damaged the board.

    I sent it back and they replaced the driver.


    What type of stepper drive do you have?
    Reply With Quote Reply With Quote
  3. 12-09-2010, 05:09 AM #3
    DJR
    DJR is offline Registered
    Join Date
    Dec 2010
    Posts
    0
    It is a chinesse Stepper Motor Driver SD-2H086MB:Stepper Motor Driver SD-2H086MB wholesaler

    The problem did start when it had a loose connection. Since then the light never went off . Do you think they is some sort of a reset ??

    Thank you
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 6 leads stepper motor connect to TB6560AHQ stepper driver board
    By wf1318 in forum Stepper Motors / Drives
    Replies: 2
    Last Post: 07-25-2010, 08:19 AM
  2. Mitsubishi CNC on lathe: alarm light flickers while threading
    By HuFlungDung in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 09-11-2009, 10:19 PM
  3. ATC Alarm Light, And Dry Run Light on after PC1 card was removed
    By Bones75 in forum Fanuc
    Replies: 3
    Last Post: 06-18-2009, 09:13 PM
  4. STEPPER DRIVER FAQ {Stepper/driver amp per phase match.
    By huios in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 08-27-2006, 02:43 PM
  5. ATC alarm and Dry run light * Help *
    By Chip Maker in forum Fanuc
    Replies: 1
    Last Post: 05-14-2006, 12:41 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules