Hi everybody.
I have problem with wiring L297 - L298n. I did everything as in datasheet but i didn't get anything but a burning smell.
Can someone please tell me what did i do wrong?
I am trying to control bi-polar stepper motor by sending pulses from parallel port to L297
CW/CCW , half/full step ,reset , enable and Vref are connected to 5 volt
Control to ground
I am sending pulses to Clock from parallel port ( 3-3,5 volts )
Instead of 36 volts i am using 24 volts.
I have 4 wired stepper motor and how can i connect them to L298n?
Thanks