[davida1234]

Install J-Box to the plate.

[davida1234]

J-box provides a central place to attach electrical connections like sensors, sensor resistors, probe, 12V hook ups
and two remote switched outlets through a single 6-conductor wire to your motion controller or break-out board.

5 Amp total load capacity.

[davida1234]

In the not included list of my previous post the spindle was omitted.
Just to clarify, the machine accepts all 80mm air or water cooled spindles which is not included in the set.

[peteeng]

Hi David - Yep Jaffas are unique Oz/NZ lollies. Ideal for rolling down the isles of movie theatres is the urban legend... Peter

[davida1234]

.

Spindle coolant system.

A low pressure, combined spindle coolant set.

Attachment 506050

[davida1234]

Slide the complete set over the mounting plate on X carriage.

Attachment 506054

[davida1234]

Coolant set installed.



- - - Updated - - -

And hooked up.

[davida1234]

.

Machine feet set.

For wet cutting, vacuum holding and pull-out shelf, the machine needs to be elevated 4" off the substrate.

1" thick plate and 1" bolts.

[davida1234]

One of the feet installed.

[davida1234]

Adjust to 4" tall.

[davida1234]

Machine elevated to 4".



- - - Updated - - -

Finally, make sure it is level on all directions.