Could you get a copy of parameters? best regards
Type: Posts; User: cnc int
Could you get a copy of parameters? best regards
Hi, could you help me with m code list for miyano BNC-34? best regards
For the first machine, you need track on the alarm on the ladder. It is going to be complicated. May be the Emergency alarm is caused by the spindle alarm. May be the spindle control board is...
Todo parece indicar que los pasos del motor no te coincidirán con los del tornillo. Debes cambiar alguno de los dos. Saludos
¿Qué información buscas?
¿Qué control tiene el torno?
Buenas tardes Julio:
Puede ser que se hayan agotado tus baterías (deben tener al menos 4VCD) y sólo tengas que borrar la memoria y volver a cargar todo (lo cual no es fácil)
Puede ser que se haya...
I have exactly same problem and i have change, drive, motor, cables, and mother board. Coul you find out the problem?
the feed hold G signal, must be 1 all the time, when you press feed hold button (=F***.*) the G feed hold sinal goes 0. This is ok. Do you have all the ladder?
Hi, i have a problem with cycle start and the ouput Y49.7. Do you have the ladder where a can see the conditions for these signals?
Hi, do you have the page where is F cicle start? G120.2) best regards
Hi asfar. Do you have a back up of you machine? i have one identical.
does some body solved this problem. The dgn700.5 is 1=feed rate=0 on my machine to.
Hi, se have lost the parameters of our machine. Could you help us with a copy of your machine parameters?
Best regards
Buenas tardes:
Como resolvió el problema, yo estoy teniendo el mismo.
Consiguió manuales de la máquina?
Could someone help me to know the part number of the turret encoder for denford cyclone lathe?
Somebody take it out for repair and i can find him out.
Best regards
Hi, could you solved your problem?
I have recently bought on, but it lost the parameter. Could you help me with a back up of these?
Best regards
Hello! i`m looking for the electrical diagrams for a psu bridgeport a025275....Can anyone help me? :(
Hi bob:
Could you intall the 4 axis?
Right now, i am trying doing the same :S
I have the same servo drive, but the motor that the 4 axis have to use is alpha i motor, what did you do?
Best regards
Hi:
Have try with parameter 20, you must change it to 4
Hi. I don´t believe it is possible.
If you have a mori seiki, use a control that help you to optimize your producction, get the maximun accurancy, speed and all the beneficts of this machine.
I...