Search:

Thank you for the suggestions. I have checked and tested the adjustments to the guide roll. I did have the opposite problem with the blades, where they kept trying to 'walk' away from the shoulder....

I am currently using a Northern Industrial 4.5" x6" 3/4hp bad saw to cut 6061-T6 aluminum plate and extrusion.

Blades
64.5 x .5 size
Raker style 14 TPI and 10 TPI

Brands
Irwin
Starrett...

If you are talking about the interior angles, It can be done with the correct sized Mill/Drill.

Looking for some help with the process of using the polygon attachment to thread mill threads. I am looking for the preferred gear ratio for the attachment, theory of how the process works, and...

I have been able to run my Taig with a reduced feed rate of 15 ipm. It will have to do for now.
Thank you for the information about the upgraded controls. The kit appears to be what I have been...

After a bit more investigation, I doubt that the motors are wired bipolar. There are only 4 wires going to each motor. The power supply is marked at 24v but I measured 50 volts going from the power...

I will check on the specifics you mentioned.
I think I will be looking for a plug and play controller box for now, then update the motors later. Any recommendations for a supplier?
I've...

I have an older 3 axis Taig CNC machine. The controller is from Deepgroove1.

Xylotex 3 axis board
Stepper motors-Powermax II, 1500 rpm, 1.16A BiPolar series

In the past I did have some issues...