Search:

Hello,

Recently, I bought 3 viper 200 drivers and 3 renco encoders.
I'm really confused about how to tunning the PID. I already read the manual
and follow the steps one by one.

Scenario:
...

Hello

i was reading the viper manual, and i found this :

A small 12 volt reed relay can be driven by the stop output to allow you to use a N/C
Estop connection. Put a reverse diode across the...

Hello Larry

I already have communication with the PC and the Viper Drive, now i tunned the motor, and everything goes fine, but whrn i probe it with mach 3 it loses the zero position!!! im using...

Hello im very interested in making a retrofit for a matsuura mc700 1979 it has the fanuc 6M i want to use the original servoamplifiers with the rutex2040 and maybe use Mach3, but i dont know if this...

Hello im very interested in making a retrofit for a matsuura mc700 1979 it has the fanuc 6M i want to use the original servoamplifiers with the rutex2040 and maybe use Mach3, but i dont know if this...

iim using a custom cable that i made, i noticed that when i connect the encoder to the db9 the red led starts flashing, i think the encoders dont work well, i will change it for a newone and try...

Hello Every body

Im working on a retrofit of an Anayac CNC mill 1989, it has 3 140v DC servomotor, im using the new viper 200, but after connecting the motor to the drive i probe the communication...

Thank you very much for the answer finally i understand how to connect it:o
And yes the logic power is independent of the Axis power source.

HOw should i connect the general e-stop relay to...

This output is supouse that works with active low when an overcurrent is presented, that's why im confussed in the manual said that this output are open collector so im not very shure about how to...

hello everybody! im using the Viper 200 for a retrofit and i have a dude about how to connect the fault output circuit to a relay to the main source motor Power. i attached a diagram is it correct?...

How can i check this?

Luis

is very strange because when its making an arc the machine stops working or suddenly it looks like it loose the reference and goes crazy, i dont know how to correct this.

for example when the...

Hello

Im looking for a mastercam 9 postprocessor for a matsuura mc500v mini master 1989 with yasnac 3000g and system M5G, I try to make my own post but i have some problems making arcs, Can...

Hello Peter

I hope you will see this message

Maybe i didnt explain me. but the spindle is not working fine because from 3000 to 6000rpm the Spindle Current goes crazy! it starts jumping from 0...

Hello

Im Luis from Mexico i already bought a DigiSpeed GX i want to use it for the 0-10v Analog output to controll the VFD i read the manual and i connect it to the Grex 5v source and put the...

Hello I think this is my problem do i need to Plug the usb cable and the network cable to the G-Rex at the same time to have communication with the PC?

Can somebody send me the diagram of the...

Hello Im Luis from MExico i bought a Grex G100 but i have some troubles with it can somebody help me?

1.- Why do i have to connect the Grex to 12V if it says in the right corner power 24V? what...