Search:

I have a great solution, sell me your machine!!!! Then buy one of my 2000 Hardinge vmc 1000 II's with chip conveyer, thru spindle coolant, renishaw part probe, etc, etc.... 5000 runtime hours. Like...

Hellow all,
I own a 1998 VM24 with upgraded single board processor and high speed software. I am looking at purchasing another machine of the same vintage (VM30) which has the single board...

You must make sure that in the g54 coordinate edit screen Z is zero before you set all your tool offsets. Set all your tool offsets (H's) first then change the G54 Z coordinate. If you run a...

I take a look at all my manuals hopefully I can find the pmc parameters, if not I guess I will have to call Hardinge and maybe they could tell me how to turn it off.

Also if I do find out which...

I want to override the alarm, or disable it. I will keep a maintence log for greasing. How do I disable or override this alarm?

I have two Hardinge VMC1000II's.
They were built in sept of 2000 and have the Fanuc OM-D controller.

Here is my problem......

The lube timer always seems to run out when I am drip feeding...

Yes I have that document along with the software and drivers.

I was on the phone with mike who was the best tech support guy I have ever dealt with (milltronics IT expert) for about 3 hrs today...

right now it is hooked up via ethernet cable. I have the network setting as you suggested and a shared folder to allow read and write for everyone. the controller is not seeing it. I think it is...

Great thanks, I will go try it out.

I noticed when the machine is turned on it says that it can't etablish a connection to E:\dell\share. I am assuming that that is the file that the service guy...

That is what my plan is. I just need help with netork settings on the pc side and the machine side.

Hello,
I just purchased my first milltronics this week. It is a 1998 VM24 with the centurion 6 controller and has been upgraded with the High Speed package. It was also upgraded in dec of 2005...

not sure on the memory size, is there a way to find out without pulling boards?
I am not sure about what options I would need turned on or where to start.

Hello to all,
I am new here to cnc zone and I can't wait to utililize all of the info on here.

I have two 2000 Hardinge VMC1000 II's (with fanuc OMD controls) that I have had for about 3 years...

Hello to all,
I am new here to cnc zone and I can't wait to utililize all of the info on here.

I have a 1993 VF3 that I have had for about 6 years now. I am drip feeding all my programs now...