[lyleap]

I have an Artsign JSM40 laser engraver that uses NewlyDraw. I also have a Top Wisdom TZL-MBAV112 DSP controller that I want to install in the Artsign. I can not find any information on the Top Wisdom board. I need a connection diagram and if there are drivers for the board I need them too. I run Windows XP. There are these numbers on the Top Wisdom board also. 2006-06 I have to assume that it is an older board. It is not the AWC680 that is currently being sold.

Any help with finding information will be greatly appreciated.

Lyle

[lyleap]

These are photographs of the board and control panel that I mentioned in the post above. I really need some help with this. The alternative is to try to recover the gold in the board and trash the rest. I do not like doing that. Attachment 244990Attachment 244988

Thank you again for any assistance you can give,

Lyle

[wawaaf]

These are photographs of the board and control panel that I mentioned in the post above. I really need some help with this. The alternative is to try to recover the gold in the board and trash the rest. I do not like doing that. Attachment 244990Attachment 244988

Thank you again for any assistance you can give,

Lyle

I have an Artsign JSM40 laser engraver that uses NewlyDraw. I also have a Top Wisdom TZL-MBAV112 DSP controller that I want to install in the Artsign. I can not find any information on the Top Wisdom board. I need a connection diagram and if there are drivers for the board I need them too. I run Windows XP. There are these numbers on the Top Wisdom board also. 2006-06 I have to assume that it is an older board. It is not the AWC680 that is currently being sold.

Any help with finding information will be greatly appreciated.

Lyle

I Have the same controul .. what is your problem

[lyleap]

I Have the same controul .. what is your problem

Hi,

I was looking for software that would operate the board and a connection diagram. I haven't looked at the system in way too long. I think I have some of the information on my computer. I'll try to find it this weekend and send or post it here.

I hope I can help in some way.

LAP

[wawaaf]

I work with corel and its very good

[aydinlaser0090]

I work with corel and its very good

hello This Aydin

i want use TZL-mbav12 dsp conrtol card 2006-06 it is old version
i need this control card driver for corel macros
i heard you use already
i have lost mine would you like any assist for me

Best regards
Aydin

[aydinlaser0090]

hello This Aydin

i want use TZL-mbav12 dsp conrtol card 2006-06 it is old version
i need this control card driver for corel macros
i heard you use already
i have lost mine would you like any assist for me

Best regards
Aydin

[aydinlaser0090]

Hi,

I was looking for software that would operate the board and a connection diagram. I haven't looked at the system in way too long. I think I have some of the information on my computer. I'll try to find it this weekend and send or post it here.

I hope I can help in some way.

LAP

http://www.topwisdom.com.cn/en/down.asp?page=3

[aydinlaser0090]

http://www.topwisdom.com.cn/en/down.asp?page=3
TL-201 corel save this file
set up and you will check vba setting

[aydinlaser0090]

http://www.salecnc.com/manuals/laser...trolPannel.pdf