[Dugg]

This is regrading X Form, Offset Contour. This is in MC X-4.

I select the Offset Contour operation, the Chaining Selection Box comes up and I select the chain or chains I wish to resize and click the Green Arrow.

Then the Offset Contour Box comes up and I input my changes.

Now, get this. The Offset Contour Box is so "tall" on my screen, the Green Arrow Button is below the edge of my monitor. Even when I shift the Task Bar to the side of the monitor, the Offset Contour Box is still too long and doesn't expose the Green Check Button. I can't confirm this op.

I fooled around with screen resolution, but to no avail. I will be humbly embarrassed and thankful to be told how simple the fix to this becomes.

[Superman]

No, not as dumb as you think.....I may also be incorrect in the solution

- R-click in the upper toolbar grey area to reload your default toolbar layout ( probably the "Design" )

[cadcam]

What is your screen res actully. are you on a laptop or desk top? what size screen?