Hello,
I recently purchased a Teco JNEV-101-H1 VFD for a small lathe using a 3/4 horse 3phase motor. I can operate the motor fine using the controls on the VFD itself, but I'm having a hard time getting Mach3 to Control it. I am using a C11G board from CNC4PC, I have hooked up other brand VFD's in the past with the same board but the Teco wiring manual is not much help. Does anyone out there have any experience with hooking up this particular VFD to a C11G board or similar. Any help would be much appreciated.
Thanks,
Blake