Search:

kia superturn 21 yasnac J50L control

looking for some really good experts for the walk thru of setting up tool offsets and part orgin on kia turn as i use fanuc and use the measure function soft...

Help I transfer program form floppy drive to dynapath memory I see busy then editing status signal. Looking at the program in memory is like the dynapath has recalculated the nc code for some offset...

i do contract cnc programming if you e mail me the dxf i can help Send Private Message

i agree with your post but this is what is happening at the control (dynapath) i use hass and fadal vmc's daily and i can use T1 with any H offset example H1 H41

example 1

Z value in the (mode...

doing the steps 1 ~5 the control has uses 2 digits for tool not 4 still, confused on apply tool length compensation in part program for the dynapath delta 40

INSERTING RED TEXT
N0010(9)T101M04$
STILL 133 FORMAT FAULT ALARM

INSERTING RED TEXT
N0010(9)T1H01M04$
STILL 133 FORMAT FAULT ALARM

INSERTING RED TEXT
N0010(9)T1M04$

thank you guru

i will try that T0101

if i want the machine at the end of the program to return to Z home just have G0T0100 this machine has an air driven motor to unlock the draw bar/release...

if i do not put a Z value in the E1 register the machine over travel (cause .100 clear plane and no tool length applied) although if i put a example -1.0 in the E Z offset register everything ok...

this is a knee type chaveler/(brigdgeport style) mill manual tool change no Automatic tool changer. the way they were doing length comp was using the z offset in the E offset page. do you have a...

tool length compensation usage on dynapath delta 40 there is H registers how to use them in program? when i put the H01 H1 say in line 10 i get 133 format alarm, i want it to use it before line 12...