The main power switch I have not looks more like the e-stop linked below but both sides are green. Is that NO/NO or NC/NC?
Emergency Push Button Switch with lock
Type: Posts; User: TimAustinTX
The main power switch I have not looks more like the e-stop linked below but both sides are green. Is that NO/NO or NC/NC?
Emergency Push Button Switch with lock
The e-stop on one machine was the first to show heat damage and I replaced it.
I have the main power switch on both machines show signed of heat damage.
Any good places to get better quality...
I have a couple of the red 60W 500x70mm machines and both of them have been blowing fuses.
The first unit melted an e-stop switch and then started to blow fuses to the point the machine won't do...
I have a couple of the X900 machines and both of them have been blowing fuses.
The first unit melted an e-stop switch and then started to blow fuses to the point the machine wont do more than...
I am looking to get into a larger machine preferably something with e 24" x 36" bed but that's not a must.
We are mainly cutting velcro, griptape, and 1/8" cardboard. I would like the option to do...
I wound up just buying the new DSP from lightobjects.
Granted it was not super cheap but the machine is way more usable now.
I resolved it by running it multiple times.
I'm trying to avoid buying the new controller if I can as it cost nearly as much as I paid for the machine.
I have had it run a number of times with no issue but the randomness of the issue makes...
I am running a K40 with MoshiDraw 2013 and it will lock up 2/3 way through the operation sometime. I have also had it just cut a random diagonal line.
I checked and made sure the controller and...
I found that it was the material thickness caused the appearance of dots and dashes. I was cutting velcro so when it would the hook it would not cut though but it was cut through the thin base hence...
I made the file in Illustrator and brought into Moshidraw as an Illustrator file so it should not be the image.
I have played with the power with no luck but I will try and zoom in on the image in...
I just picked up a K40 laser with Moshidraw 2013. When I engrave everything seems fine but when I try to cut an outline I am getting smooth lines vertically. dashes on the angles and dots on the...