I have got this E252 alarm (tool in toolchangerarm).
Its not possible to do a toolchange with M6, but if i do a M66 (manual change) and then a M6 directly after the ATC will work once.
Any...
Type: Posts; User: swedish steel
I have got this E252 alarm (tool in toolchangerarm).
Its not possible to do a toolchange with M6, but if i do a M66 (manual change) and then a M6 directly after the ATC will work once.
Any...
Hello. Did you recive my email?
Skickat från min iPhone med Tapatalk
I cant send email to that adress.
Hello!
Looking for post for a Goratu Lagun GBR 4 with heidenhain TNC530
It has a head that turns in 2.5degres steps.
Cool. I have the the connector with wires, just have to se if its hooked up to a soleniod and go from there.
Skickat från min iPhone med Tapatalk
Today i looked, and yes the light becomes red when i start m83. But theres no air blowing anywhere
Skickat från min iPhone med Tapatalk
Thanks i will look in to that
Skickat från min iPhone med Tapatalk
In my case nothing happens when i try M83/M84.
Skickat från min iPhone med Tapatalk
Ok thanks for the answer
Skickat från min iPhone med Tapatalk
The soleniod valve is there and everything. Is the a setting to make it work?
Skickat från min iPhone med Tapatalk
Hello. Is there anyway to enable the auto airgun feature by myself on the umc 750 if you didnt bought that option??
Skickat från min iPhone med Tapatalk
I dont need rotary milling. Just for 4 axis contour and 4 axis pocket :)
Skickat från min Nexus 5
Hello im looking for a post with simultanious 4th axis movement for a Haas vmc.
Using Gibbscam 2012,2014
Skickat från min Nexus 5
Take a look here and u will learn.
GibbsCAM Training Videos
Skickat från min Nexus 5
I'm in need for a st30y post also. It would be great if someone could help me.
Skickat från min Nexus 5
Anyone got a working post for this machine? The one we got from our swedish gibbscam dealer is full of faults and it seems hard to explain to them to fix the problems.
Skickat från min Nexus 5
GibbsCAM Training Videos
Yes i think it does the work well. I've tried 3+2 and full 5axis milling and it works. Haven't tried highspeed yet.
The post processor we got from our swedish reseller still need some work to...
We are using Gibbscam 2012+.
Skickat från min Nexus 5 via Tapatalk
We got our UMC-750 installed 2 weeks ago. Its the first 5-axis machine i run, so i have little to compare with. My impression is that its pretty ridgid and a very nice machine.
Skickat från min...
I would like to have some 5 axis samlples to. Gibbscam 2012
[email protected]
Skickat från min Nexus 5 via Tapatalk
Check the inductive sensor on top of the drawbar. That solved the problem for me on our mcv 1700
Skickat från min GT-I9100 via Tapatalk
I got the same machine and it get stuck on the M84 code when i try to change tool. Any idea's?