Search:

I don't have one on a table but have owned mine for about 18 months.
I bought it specifically because it was a low cost, light weight DVI unit that had a machine torch available for it (in case I...

There are several other Lightning CNC threads here (some are locked for posting).
One or two of them will give you the info on the owner, his address, and other info.
Hopefully that might help you...

Good to know.
I wish you would have taught them how to install one on a motor.

I don't care to speculate, I care about providing as much info as I can.
But since all the FB, YouTube, Twitter accounts have been canceled I see no reason to not exploit that for the benefit of...

That would be an assumption on my part.
I didn't dig through any of the movie or writing credits.
You could very well be onto something.

Edit:
It does appear that Cleandrew Smith aka...

This may help you if you have not already found this: lightningcnc.com Whois Lookup & IP | Whois.net
From that I was able to determine the owners name Cleandrew Smith (not the celeberty by the same...

Demo version on Mach3 and Unlicensed on SheetCam.

Cool, and thank you.
I will start my on post as I build this corner leg, tons of rain here so I will start tomorrow.

Sorry tromping on the OP's post but it was timely.

How can I tell the difference?

It would seem Lightning CNC had bailed.
http://www.cnczone.com/forums/general-cnc-plasma-oxy-fuel-cutting-machines/240850-lightning-cnc.html#post1562012

I will deal with that when I get there.
As of this morning they have deleted their FB page and closed their YouTube channel.

I hate for this to be my first post here but I think I am in a similar situation.
Just unpacked my 5x5 table today after getting back from NM and I'm missing a corner leg.
Obviously I can build my...