What I'm working with is a Taig CNC with 3 G251 drivers, a C10 parallel board, and a KL-600-48 PSU.
I've recorded a video (below) showing the issue I'm trying to track down.
The power is...
Type: Posts; User: DarkSabre
What I'm working with is a Taig CNC with 3 G251 drivers, a C10 parallel board, and a KL-600-48 PSU.
I've recorded a video (below) showing the issue I'm trying to track down.
The power is...
It has almost been a year since you guys helped me pick out what I wanted to order, so I figured I would bump and say thanks again! Most of the parts seem to have worked out nicely :rainfro:
I've...
Well, [crosses fingers], I think it might be fixed...
I grounded lots of things, to no effect. Then eventually figured out that the AC side of the 48VDC PSU for the stepper motors was not...
Okay, ground the mill itself or other parts too?
So I've got an issue that cropped up after moving the mill to a new location, though it may have been present slightly before. So enough things changed from the move that it has been hard to track...
Heh, maybe it will be useful to other people later.
Yeah, I've not put a whole lot of faith in the looks of the kit. I already have a respectable set of digital calipers and from reading Carter's...
Initial post changed a little...to actual mention what I'm trying to do and what I'm asking. Oops.
Trying to make sure I'm not missing anything obvious or if people have any recommendations!
I'm going to be starting with wood, but I'll eventually be doing aluminum and some steel. I'll worry...