Search:

Well I bought some Keilling 425 oz/in motors and there very nice weight, can't wait to get them fired up!

But this poll is for what would you use? ( given a average setup! )

I'm going to be purchasing a Gecko driver for my 3Amp 6V steppers. Which I seems to be very common.

I'm only a hobbiest...

There are several leads on this power supply that I have not seen before and was hoping that you guys could help figure them out.

Here are is the list: (left to right)

-- IN --
220v .........

What what I'm learning is that most NEMA 23+ motors will need arround a 4 amp controller. Along as the board and provide this, there haven't been too much say or biased towards one controller vs...

I use a 4 tone eclectic clam press to press plastics and magnetic materials. Although I'm not sure the density of the plastics you are pressing, we cut .050 mill plastic with not much effort however...

Select the IC you would or have used in your DIY stepper motor controller board.