Search:

Hi.

Please refer to the attachment for the setting. However I should mention that I no longer use Walter. I now using TB board, Walter driver board fried after 11 hours running non-stop for 3 days...

Hi.

I received Router 3040Z today, after setup everything, I tested the machine using simple g-code made in D2NC. Here the g-code, it is radial slot.

(D2nc generated code)

G17 (set xy...

Hi.

Here is the router.

http://i1100.photobucket.com/albums/g418/hanny77/Slide2.jpg

http://i1100.photobucket.com/albums/g418/hanny77/Slide1.jpg
...

Hi all.

I bought Walter 6545 from CNCDIY.org. I did noticed they received positive feedbacks from their customer. They even posted the manual at their website. I am happy with the purchase but my...

I guess I wasn't brave enough to push the jog button. However after I forced myself pushing jog for Z axis, I find out:

G0 Z2, the axis went down.
G0 Z-2, the axis went up.

So I change Dir Low...

Guys, I have been reading in the forum but not much information about Walter / CNCDIY but I stumble upon the link below and guess what the router finally rumbling to life!! :o
...

Guys, this is link to youtube made by CNCDIY. The router in the video is the same model with the one I purchased. Hopefully someone can help me figuring the pin in Mach 3.

‪WALTER 6545 -...

Anyone bought this machine out there?

I bought the router from CNCDIY.org few months ago. I have set up the machine according to the manual at the website however, the machine doesn't move at...

I had my TB6560 running nicely after found this thread.

http://www.cnczone.com/forums/general_electronics_discussion/98417-need_help_tb6560_board.html

I set up the pin wrongly in Mach 3. This...

Hi David.

May I know the setting?

I have been reading this thread but it really beyond my understanding. I just need basic setting for this board in Mach 3.

Thank you.
...

I am a newbie too but maybe you should try Mach3 or EMC depending on your OS?

Thank you Doorknob. Devouring the thread right now.

Thank for the reply.

Checked. Pin 14 and 15, are 5V.

The same problem occurred when I attached the cable to the laptop. Just now I tried running Mach3 from the desktop connected to Walter but...

Hi all.

I am totally new to CNC world. Recently I started learning CNC so hubby DIY a simple CNC router for me to familiarize myself with the machine before moving on the a real CNC...