Search:

My understanding from my machine, and many hours of looking around, and trial and error is this. Auto tool change is machine specific command, within the machines ladder logic (IE its brains). So...

Haven't heard of the VM-490, even with all the searching I had to do on our VM-460. As for Okada, they went out of business a long time ago, so searching for help falls to the message boards.
Now, I...

Our machine doesn't have a selector switch to go into tape mode, it is based on the I/o switch setting, where it reads the program from, either the drip, or the controller. And our machine limit on...

On the machine control, for ours anyway, using the dripfeed, the I/O setting is set to either 0 or 1, cant remember which is which at the moment but it breaks down as follows, and I may have numbers...

For me, 1780 wont open up pre-existing files, well it might if you wait anywhere from 15 min, to 20hrs for it to open. But most the time it just wont open them at all. Thats on a win 7 computer... ...

Hell, since the update to 1780, it wont open any files half the time.
The hard drive spins away, but thats it. Doesn't matter if its a new created file, or an old file, same result. Even trying to...

I have been thru the headach and months of research, mostly the search.
If give the specific type of Fanuc your dealing with, as well as what your trying to acompolish, we might be able to help...

I wont go over the problem specifics again, you can look at what i have posted in past about ATC DRY RUN lights on, and the machine sitting in not ready.

My question now is, we have replaced the...

I need to find someone who has this machine, We have lost the ladder logic in the machine, and need to find an identical machine to get a copy of the program on the chips. If anyone could assist, I...

The board has been repaired, and if correct, once put back in the machine will be back where it was prior to it's removal and self-destruction.

The ATC will not do its job.
The Cycle Start light...

My electronics wizard of a friend, is going to replace the damaged chip and diagnos the board. :idea:
If that doesnt work, then yes will probably have to look for replacement, but they seem...

To start, I have an Okada VM460, with Fanuc 3M controller
In process of doing a drip-feed upgrade, parameters & programs got erased.
We had the parameters recorded, and where able to get them back...