Search:

I don't think there are many shops if any that don't have at least one accident under their belts. For me when I first started at my current employer my boss tried to finish the job I was working on...

I'm sure you have solved this problem already but where exactly is the program hanging up? When cycle start is pressed? Before it goes to pick off? Are you checking it using the hi speed check?

I know this is a old post but it's easier if you just write any sub spindle work as a sub then call up the sub when its needed. This is from my L20X


$2
T3000
G50Z0
G600
M98H1
T3000
G650

Could always find a a piece of tubing with a OD that is just a bit smaller then the ID of the tubing that you are wanting to cut. Then shim the smaller piece so there is enough clearance on the...

Depending on the length of the piece your wanting to cut off you can set up some sort of clamp to hold the piece in place.

Then I have no idea. I think put a call into Citizen see if they have an idea or call LNS.

try running that program with the loader disconnect on and see if that works

Just a second thought the last few LNS barfeeders we have gotten have had bad wiring issues, to the point where we had to run the machine with the loader disconnect on so it would EOB correctly. ...

Can you post your code on here maybe some more eyes can see whats going on.

I didn't think M55 would be dividing anything. You don't have any strange values anywhere, or any other code on the same line as the M55 do you?

^ looks good and yes your sub-program needs to be in the main program just have to call it up in the main program when it detects the EOB.

26 here

You can order it from D & D Tool and supply. The number for the Anaheim office is (714) 632-5100.

I also use Blaser Swisslube Vascomill 22 in my shop.

We are allowed to have mp3/radio's as long as we are wearing headphones.