No you just set it in parameters as far as I know
Type: Posts; User: Kenneth434
No you just set it in parameters as far as I know
Sorry for the slow update but here's where I am at now.....
tc429..... No toggle switch on mine to flip. Thanks for the advise on the cable..built a new one.
fordav11... I tried an rs232 tester...
Also, these are the same parameters the machine have been set on since I've owned the machine for last 8 years
I checked my parameters and they are:
0020: 1
0021: 1
0022: 1
0023: 1
5001: 1
5002: 0
5003: 3
5011: 1
5013: 1
Thanks for the reply Al. I just tried the 3 wire cable and that didn't work either. The only only plug is a Honda plug next to the rs232 plug on the back. Is there another RS232 plug hid somewhere or...
I have a Daewoo Puma 10S with a Fanuc 10T control. Lathe has been punching and reading fine for last two years and has now started throwing the SR820 - DR OFF alarm. I have replaced the cable...
1
I'm working with V24. I've attached the post and Predator rpl. file I'm using. I could only figure out how to upload them in txt. form. Any help will really be appreciated!
Had some luck modifying the rpl. file for 10TA and able to get it to rough OD correctly but will not simulate face in canned or simulate G76 threading. Also will not simulate a finish cycle in...
Please help!! Need help changing Predator so it will simulate canned cycles on Fanuc 10T. Anyone had any luck with this?
Thanks,
Ken
Still looking for help on this. I have replaced both proximity switches (tool in position and tool counter), the limit switch box (that also says it is a tool counter) and all five relays for the...
Hello Gentlemen..
Was running a part today and caught turret going to tool 11 instead of tool 12 like programmed. E-stopped immediately and reset it. Tried to manually change tool and turret was...
My 97' Vf-2 is having trouble changing between hi/low gear. Have looked at multiple threads here and elsewhere on Internet. I've sprayed lube through air lines; took cover of spindle and pulled of...
And I installed it on a 1997 VF2
Got mine yesterday and installed. Worked fine after i turned the ribbon cable over (thanks for the help on that John). Loads and downloads files exactly as floppy.
Looking for some help locally with Haas VF2 that I just bought. New to CNC and need programming help, etc...
Thanks,
Kenneth
New to CNC and just purchased this lathe. Need any manuals on a 1988 model Puma 10s with a Fanuc 10t control. The serial number is 380213. Thanks in advance for any help.
Kenneth