Search:

Need simple G-Code (CNC)

Hi, I have been working on this little pet project for sometime now. I need someone to interpret the drawings I have provided and write G-code for it. It's a super easy...

so.....after much troubleshooting and miscellaneous what not....i found out that i just needed to load the Gecko XML file into Mach3....looks like my settings weren't correct.

Good information. Ok, well then I thought I had my motors wired right - I actually used the Ohm meters method to verify the correct winding. I guess ill double check this time around.

The motors...

Hi all, my motors wont turn. I have Mach3 configured, as instructed based on the machine i'm building + PC parallel set to EPP. I am not getting anything from my motors; But gecko is responding as...

Yes this does help! Thanks for the great info and quick reply. I am also going to use a multimeter to check if my motors wire configuration (2phase red blue green black wires) has continuity just to...

Hey Did you ever figure out what it was? I had a similar issue when i first started up my gecko configuration for the first time. My motors wouldn't run and I think it's because of my hack job...

Hey Everyone, really excited to get my cnc hobby started. I am in the work of building the KRMx01 right now. I am about %40 complete. I hope to learn and contribute to this forum regularly.