Search:

was right the first time.

completely.


Roy

A1 is voltage to the magnet. L1 is fed thru the motor direction switch and out pin 10 to A1 then thru the magnet and out pin 14 to L2 any switching of the motor direction switch will interrupt the...

it's not just first hand knowledge their lacking it's knowledge in general and they are determined to show it.

Roy

well I put in a good skf bearing and it is very quiet now. I got this head used because the rear VS pulley made a lot of noise and the owner just replaced the head instead of dealing with it. when i...

I have a Chevalier VS 3hp head on my grizzly mill and it started making a vibration and loud noise when lowering the quill in back gear. When the quill is up it is quiet but as you lower it it gets...

I can tell you from experience that grizzly if they do any inspections in china or wherever as they claim they don't do a very thorough inspection. I have 9 large pieces of grizzly equipment (mostly...

well after three years of studying, getting software and trying to learn it this project is finally moving forward but in a little different direction. while at the grizzly tent sale i saw this cute...

to answer your question yes you can use the stock bridgeport switch to control the vfd. it is very simple. i didn't want to mess with my switch and i use my vfd for my mill and lathe so i just made a...

well you asked for it so here is my intro post. my name is roy andrews i live in upstate ny. my main interest is in converting an M head bridgeport to CNC to play with. i do a lot of hobby machining...