I do have some asterisk on the tool data and tool layout page
Type: Posts; User: rhurt
I do have some asterisk on the tool data and tool layout page
it just shows 20 NMI alarm and all you can access is the parameters and tool data ,it;s like PLC isn't turniing on
I had a short on the solenoid that goes to the tool setter and have it unhooked now, but now I have an NMI emergency stop alarm and machine will not turn on hydraulics or chiller and control will...
I have a short when I plug in the input output boards it shuts control power off and now it has the 20 nmi alarm and has 225 percent on the Z axis load meter
I had the same problem , found the mar2 relay in the door to be bad chaged it out and everything came on
I had done the reinitialization with the dip switches and now I cant access the hidden parametes , I can only access the normal parameters and my f2 &f3 keys are not powered (leds dont light up)...
Does anyone know hpw to turn some of the special features on the Delta 40
like conversational graphics or buffered input and also the harddrive feature
Autocon tells me I have to pay them to turn...
Does anyone know how to adjust the backlash on a Delta 40 using the setup
screen ,and using RX AND RY values ? I know you're suppose to measure the backlash with an indicator and put the values...
How do you program the air blast to turn on and off in the program? Also
how do you program a slot with Mazatrol (M-2 control)
its not a Honda plug its just a rectangular plug , but the problem is its not like a 15 pin pc monitor plug,and I dont have a schematic on it ,and dont know how to hook it up,theres a board ...
how do you hook up the TTL monitor? does the nine pin plug into the board in
the rack below the monitor,the old monitor has a 15 pin square plug
what is a ttl monitor? and its color
can anyone tell me how to wire a computer monitor to a mazak m-2 control,
so you dont have to use the mazak monitor?