Search:

Thanks for y’all’s help. I got it working accurately now.

And by 4 inches I actually meant about 1/2 an inch, my mistake.

Yes I did. I did a dry run without the spindle on, it returned to the zero with a very slight change in Y-axis. did a dry run with the spindle on and the Y-axis had shifted about 4 inches. Today I...

https://www.damencnc.com/userdata/file/1750-1_DM556_datasheet.pdf

This is the data sheet for the drivers, as far as I can’t tell the dip switches set the max current draw and the pulse/rev, the...

I can set the max current draw supplied to the steppers from the drivers, right now that’s at max. The chain has been fine so far, will say the couples they gave me did not size up to the actual...

The only axis on my machine that’s controlled by a screw is the Z-axis. Based on a quick bit of research that I did, it was describing screws and the “play” between the threads. I don’t know if this...

I have Nema 34 motors and DM556 drivers. The voltage from the power supply is 220V and the voltage from the driver is 20-50 each (for three) with a max current output of 5.6 A. Right now I have it...

So what would be the fix to that? Slower feed rate?

I don’t know exactly if this is where it belongs in the forum, but I’m new to CNCing so bear with me here.

I got a CNC machine (specifically the greenBull) from Build Your CNC, and assembled it...