Search:

For some reason out of the blue yesterday my z drive locks up when trying to jog up at full rate. It sounds as though its getting pulses to go in both directions and if you hold the jog up button...

I am trying to cut a mirror image on a 4 x 8 Sheet of MDF. The pattern has a right and left side on it and a pocket on one side and then a pocket on the opposite side. I've tried creating the mirror...

Thanks for the info, I'll try it in the morning, I'm sure that is exactly what the issue is.
My Dad may get his christmas present afterall.
Randy

It is a new machine, its a Vortech 5 x 10 running Mach 3 as the controller software. I suspect that it is a reversed axis, I can't say for sure that it ever worked correctly as the test cuts I did...

I need some help, I'm using Mach 3 as the control software and Vectric Cut 2d. I've built a vector file that looks to be fine when you view it as a simulation but when the code runs the image that is...

I have a Vortech table as well, did you ever have any luck setting up your probe to work with your table.
Curious if you were able to make it work and what input pin configuration you used.
Thanks...

I have a Vortech router and would like to be able to connect a centering probe to the table.
Has anyone out there been succesfull in connecting a probe of any type to a Vortech table??
Thanks
Randy

I feel your pain, went through the same thing, downloaded just about every trial software on the market, purchased the bundled Cut2d and PhotoVCarve from Vectric last night.
Will lilkely end up...

Hey, I know this may open a pandora's box with many opions but here goes. I'm in the process of trying to evaluate a CAD/CAM solution for my new CNC Router. I'm new to the whole process, have figured...

You menitoned that you may need to connect a 0.10uf capacitor between the I/O pin and the ground. Can you let me know how you would know this or should it just be done in advance?? Can any damage be...