Search:

Great looking machine Do you have a best guess at how many $ you will have in it when done?

Hi does anybody have a post for sodick ex21 control they would share that will work in esprit 2011

Thanks

Any body using rv antifreeze in there cooling system?

I have a router that uses a g540 and mach3 I want to build a 4th axis for it my question is can I mount a 200 step per rev motor directly to the end of it or will I have to use timing belt and...

Can anybody explain the difference between cnc88 and a cnc88hs ? Can the 88 be upgraded to the cnc88hs

Thanks

Can you put a gage block in and touch 1st side zero it out then go touch other side should tell you what the runout is altough i dodn't think you should have much runout if the guide is good

Has anybody ever tried to retrofit a sinker edm with mach3?

Are you talking paper tapes or cassette tapes I have intructions for cassette I could fax you

IS IT A 110H?

I have not seen a manual for the vmc 20 any where would it be the same as another model?

Does anybody know how much a early 90's vmc 20 weighs? and what the tapping capacity might be ? and wheter or not it can be run on 240 v with a wild leg?
Thanks

no the monitor does not come on at all power light is on but nothing shows up on monitor

ok i got the power figured out but machine will not boot up talked to mag i forget his name but he thinks it could be mem mod they will check it for $250.00 reload software if it can be done for...

my incoming voltage would be 230 do you have a dia. for the transformer i could not find one on the transformer its self i only have 220 at the spindax so i woul\d suspect that would be my problem

I hooked power to it but I don't have 110v to the control power supply module any body know where that comes from ? any ideas what the problem might be?
Thanks

I just bought a 500 machine at auction and am just about ready to hook power to it any thing I should know before turning it on I don't know if it ran or not the building had no power so i might...