Search:

I take that back. (I don't know how to edit what was previously posted). My setup is woefully under powered. It's fine for no load running with the gibs set to loose. After a bit of research I'm...

I'm running my X2 with these 3pcs Nema 23 Dual Shaft Stepper Motors 382 Oz-in Rated Current At 3A using the Stepperworld FET 4 board, a 600W PC power supply and a set of power resistors mounted on a...

Boil them.

Nice job! Thanks for your run down of problems and solutions. I've planned on doing this to my CNC (which is about 98% ready to go),

I'm in Cleveland, but through secondlife i can meet up with people all over the world, demonstrate and discuss 3d objects in real time with all those people.

Secondlife is getting voice now too so...

Is this really the dead horse these lack of replies impies?


AT least how or why this is lame?

anything?

I did a search in cnczone for secondlife. Does anyone else here use SL besides me?

For the uninitiated, SL is a 3d online platform in which you may construct innumerable objects (albeit through...

2 small bits...
noticed the focusing fixed the alignment problem? That's very likely due to chromatic aberation. co2 IR is around 10000nm vrs red diodes @ 653?

i read recently where very rapid...