Search:

Any updates on this? I’m having this issue in my 17 Lynx LSY

Sure,

Machine: $3000

C11 BOB *$129.00

3 x G320X *$344.85

Encoders - $123.81

I don't think I ever shared my 1st cut with the machine before I started the rewire.

The surface finish on the edges left a little to be desired, largely due in part with using an 1/8in...

Yes a Fadec UMC-10. One of Dave's machines. It's gonna be rough but I'm sure I'll survive with it.

I see. Thanks for trying.

I did a little cleaning up of the wiring lastnight. Sadly, this machine will be put up for sale once I get it all cleaned up and running again. I purchased a 2nd hand...

More good news. Been messaging all morning.

He posted a few new videos.

This is his new SVM-1

SKYFIRE SVM-1 High Speed Aluminium Cutting Demo - YouTube
SKYFIRE SVM-1 High Speed Steel...

Got an email myself.


http://i.imgur.com/aOGuzCO.png?1

Not sure where you'd like a pic of. Can you explain a little more?




I'd do a conversion again. My biggest issue was the encoders. Once I decided to get new ones all problems were solved.

Feels great. I still need to fine tune it, rewire control box, and get the spindle running with Mach but I'm pretty happy so far.


Here's the spec sheet on the motor.

Click to enlarge
...

Ok guys and gals,

I got the machine running. Well, all Axis. I canned the OEM encoders and went with AMT-102v's and that solved all my pulsing. I'd still like to test the factory encoders at a...

Max is 50mA in them.

I can try the PSU.

I thinking I may have to wire the encoders via "Using HEDS Encoders With Geckodrive Servo Products"

http://www.geckodrive.com/using-heds-encoders
...

Hey guys and gals,

Im having issues getting my system to drive.

I wasn't sure what sub to put this in so I just added it to general.

I'm getting pulsing in the servos and they fail, reset,...

I actually disabled it. I forgot to add the pic of when Mach loads.

The pic with just the USB power LED is when only USB power is added and non other.

The pic attached is when 5v is added and...

Ok guys, I got most of the stuff that is not staying pulled out and wired up the PSU to test the output.

I created the wiring diagram for the servo PSU. Still working the the rest.

I also...

Ok guys,

I decided to go with the Gecko 320x's and a C11 BOB. I now have those on hand.

I plan to use the spindle motor, speed controller, servos, encoders, and PSU that are on the unit ATM

...

Thanks for the reply Fastest

From what Ive found, the Benchman was made by Prolight. Same machine minus the ATC. My machine shipped with the enclosure yet was removed at some point.

Its...

Hey guys and gals,

I'm looking to retrofit my newly aquired Prolight 5000 (Benchman 5000) to run Mach 3.

I received 3 whale3 drivers and a parallel breakout board with it.

I'd like to get...