Search:

I need a programming manual for a Raskin RT 90 punching machine and can't find one. If you know where I can get one or have it in pdf format please help.

Thanks

aka,
Try this http://cnczone.com/forums/showthread.php?t=8814&page=9, there are several different modified versions of a program originally created by Wayne. Start at the last page and look through...

see
http://www.cnczone.com/forums/showthread.php?t=84643

Waleed,
It is very hard to find good programming software that doesn't cost several thousand dollars. Check out www.turretprogramming.com for inexpensive punching software. I have heard good things...

Take a look at this website. It may have what you are looking for.
http://www.vero-software.com/products.php?page_id=2&sub_id=17

the amada pulsar 2415 is a 2500 watt

Bryden,
First of all thanks for your repy. I would like cutting conditions for the following:
18 ga. (.048) crs
16 ga. (.059) crs
14 ga. (.074) crs
16 ga. (.060) stainless steel
14 ga. (.075)...

Jixxer,
When material is formed or rolled the inside of the material is compressed and the outside of the material is stretched. At a certain point it neither stretches or compresses. Usually it is...

gwittlock,
I converted your nc code using the convert dxf program. Importing the dxf into cadkey, gpuncher and gcad3d the circle showed up. I tried several viewers and the circle did not show up. It...

Your best answer would be to contact bobcad and ask them. Since you purchased from them (I would assume) they will give you the answer. Some software companies will allow license transfer to another...

If you are looking for a lower cost software check out Profab Lite http://www.appliedproduction.com/ProFabLite.htm. It is a very good programming software for the price. Although it may not have all...

We recently acquired an amada 2415. It cut really well until several changes were made to the cut conditions. Does any one have some type of cut condition reference list for this machine? I need some...

Here is a link to create an ellipse in GPuncher. It looks fairly easy to create.
http://turretprogramming.com/Documents/GPuncher_Ellipse.pdf

Here is the cable pin assignments for a Nisshinbo PAL-510T controller. I believe all of the Nisshinbo's use this configuration.

Contact [email protected]
or visit http://www.turretprogramming.com and contact services from there. They should have a manual for your controller type at no charge. The page appears to...

Check out http://www.cncsoft.com/punchsim.htm for a punching simulator. If you want to go one step farther and completely reverse your gcode check out the GReverser at http://www.metalpuncher.com....

If your controller is a PAL-500T or PAL-510T the program must be in this format. Make sure your baud,data bits, etc are set to match the machine controller. I send to 2 HTP 100's that should have the...