Search:

UPDATE ON MY G71 PROGRAM
I followed the advice from the all that responded and SUCCESS!!
I entered the value 3 in the T section of my offsets and the program now runs the finish cycle.
Thank you...

I have an unrelated question.

Is there a way to get the chuck to not spin during our dry run cycles?

*****UPDATE TO MY QUESTION******
We just removed the M03 and the dry run cycle worked as...

Fordave11
I can not believe I did not find that.
Perhaps I did not even look for it.
Regardless, many thanks for taking time out of your day to attach that and send it to me.
It is very much...

fordav11
Yes, this program works on 3 other Funac controls and has worked for about 17 years.
I purchased this Femco as a back up to my TU-30 Ikegai Lathes.
I just need it to do a secondary...

I did check this entry.
It was set to zero.
I have many different size parts to run with this cycle on this machine.
I will be setting up another size today. I will update my progress.
What I did...

Thank you .
I will double check this entry

dcoupar:
Are referring to the Z axis when you speak of the T?. If so yes, that is set correctly.

ghyman:
Many Thanks. So it was set correctly. My bad. Spinning to many plates.

dcoupar:
Can I ask where in my the G71 program one would insert a T. I have never used a T

dcoupar,
Thank you for your reply:
I have a .0312 in R while using a CNMP432 insert. That seems that is incorrect as it should be .015.
I am not familiar with the T value. Can you explain please?

I have a Fanuc Series 0i-TC on a Lathe
I program the following G71 cycle with a .050 clean up pass.
The control shows that the tool is leaving .067 for clean up pass
Then when it takes the clean...