I have a problem with my new At Din 5 Keyboard. The machine loses connection when I transfer the Panel connection from the Key Pad to the AT Din5 keyboard this is a new keyboard from the Factory. It...
Type: Posts; User: cnctools
I have a problem with my new At Din 5 Keyboard. The machine loses connection when I transfer the Panel connection from the Key Pad to the AT Din5 keyboard this is a new keyboard from the Factory. It...
I will try this setup.
It will be connecting both keyboards at the same time from bootup, without transfering between the two Din5 terminals.
Thanks
cnctools
Can you remove the draw bar cover and see how much clearance there is between the socket wrench and the draw bar, then turn the spindle on to observe what is happening. The leading edge of the hex on...
I had a problem with my mill's monitor, plugged in a pc monitor with no results, Called Emi-Inc for a new board, replaced it along with a new hard drive, Windows 98 OS . Now I Boot up in Windows 98...
The DNC software runs on thr RS-232 Port. I have seen USb Adapters and Jump Drives on the internet. I have not heard how well this works.
Downloading programs is easy if they are small enough to fit into a 640 k block in Dos. I copy and past my progams in to windows 98 to the PGMFiles directory on the Machine. The machine I Am using is...
I have one of these machines that I use every day. I Up graded it's Mboard with one from EMI along with a Hard drive running Windows 98 in the Background while the Machine runs from Dos. The Control...
on the subjest of updates. Can the Eztrak Controls and software be replaced or upgraded with a more up to date system from Harding? etc. What controls lend themselves to the eztrak conversational...
I'm Having simular problems with booting up. the program hangs up after calling the TrueFFS-Bios program. I think this is the disk on a chip setup. the machine has a uttler hammer control system. My...
George, My research shows that this Bridgeport is a 3 Axis Ez-Trak a program disk volume label of EZ1/3-ch-634 Ver 4.00.08/5.66 Dated 9/20/99. A Diagram #D2598660 is noted on the Power Cabinet. My...
I work with an ez trak mill, occasionally the screen gets garbled with previously used screens which overlap each other. This continues until the screen becomes unmanageablely confused, but...
I have a eztrac milling machine.It has several os/2 plug ports behind the display panel. How do you enable an os/2 keyboard from these ports? I need to edit the machine programs with text at the...