thanks for the help
Type: Posts; User: kwhite2
thanks for the help
how could one get tool diameter offsets to load into offset page thru the program, sometimes operators forget to do this, want to control this if possible, thanks.
using VQC to run probe cyclesn on Haas VF-1
OMP40 series, I think one is a little older than the other, the battery compartments are different.
i have a renishaw probe that went on the blink, pulling another probe(same style) from another mill, but it doesnt recognize it when i go to calibrate, is there somewhere that we would need switch...
the material is thermal stressed relieved, hey thanks for the input, gives me something to work with, not sure this is route i want to go yet
think we could hold coplanar .0002 flatness and // on 5" x 10" x 1.25" aluminum plates that have about half the thickness channeled out leaving .5 walls with this type of system.
anybody using grid type vacuum chucks, or any type of vacuum chuck i guess, on vertical mini mills, whats your opinion on them for work holding, boss wants me to look into them, thanks.
when i run calibration, it doesn't give me diameter in #188, I then go back and check it using 9814 and thats when the size difference shows up in #188, using a known dia/set ring. I probably need to...
I have loaded probe in same position everytime, I have got the runout in the the probe within .0002, I run calibration programs 9804 to set stylus, and no matter what I do from the above mentioned I...
hello, looking for some help loading multiple programs from usb to memory, cant seem to get button sequence to establish source and destinations properly, I think thats what I'm trying to do, I can...
thanks guys, calibration and orientation are the key factors I found, thanks for the help, happy holidays
hello,
anyone know if there is one variable that controls probe tip size, Im getting different results, up to .005 on diameter when running a bore check, even after calibrating several times, does...
anyone know of any type of maintenance mode on mini mill, trying to one step it thru tool changer, having some issues with it hanging up sometimes, trying to clean it out etc....thanks
something to work with, thanks
anyone know of any engraving apps, preferrably free, for VF mill, found the one in the quick code, but was wanting to get into different fonts etc...ariel italic or din17
also whats a good cutter...
trying to get my LC-20 lathe spindle to orient, wont work with just M19 or a C callout, it looks for spindle orient spec.? OSP5000L-G control, any suggestions greatly appreciated, thanks
thanks!
hello,
anyone know of a good resource for 30 degree countersinks, 15 degree per side, thanks
yes true, but wanted to see if there are options using macros to cut down size of program.......using probe updates, tool checks and multiple work offsets on the single part program.....HAAS VF 4...
have single part program that is somewhat long and complex, was looking for any suggestions/help on how to run this program for multiple parts on one set up, using macros, thank you.
trying to probe .125 dia, probe tip is .078, cant seem to control back off distance, runs into opposite side, is it possible to control with variable, using 9814