Search:

There’s an unacceptable end of a line, as the error already says.
Show us your program 1:1, then it’ll be sure possible to help you.

However I’d like to know your train of thought about “1” in
WZINFO=$TC_TP2[_TNR,1]
What did you want to reach with it? And where do you have it from?

The problem is in the following line:
WZINFO=$TC_TP2[_TNR,1]

There’s only one parameter allowed in clamp. The T-number is clear and it’s enough.
What are you going to use the second one, I...

What is the alarm number?

Just ask EMCO. The error is made and output by the manufacturer… not by Siemens.

Look in the tool management. There should be a softkey “new cutting edge” there. You can plan several cutting edges for one tool there. They will be called with e.g. T1 D1 (tool 1, cutting edge 1),...

Didn`t know that. So it is not that easy i thought.

It might be that the "change language" softkey is written in german also. In this case the name of the softkey is "Sprachumschaltung".

Well, there must be a softkey "change language" available. This softkey you might see after pressing "Inbetriebnahme". This is the german word for start-up or settings. By pressing the Softkey...

It doesn’t change anything for the general path of the tool. It just moves along a similar path in another position with active CER (G41/G42). At least I think so.

Try DELDL[t,d]

Well, it’s already called somewhere. Make as follows:
Start the program, when the error occurs “NC-stop” is coming, then choose “program correction” or “correction clause”.
The program editor will...

Hello

Is your channel in reset-status? I’m not sure, but maybe a reset is necessary. After change PowerON or NCK-reset.

Or do you want to describe a variable with a program?

Then you can try...