Search:

Hi mike it's an arrow 1000 A2100 control. As stated the manual says it should run in x& y only perhaps the manual is wrong. Other machines I have worked with also run through the program with no...

Hi according to my manual when performing a dry run the xy & z axis should not move except for tool change. Mine however runs everything in rapid. Any ideas on how to stop this. Arrow 1000 with A2100...

Hi does anyone use Gibbs to upload/download program's. Trying to use it but doesn't transfer anything.
Cheers
Steve

thanks for that my manual only shows the arrow 750,
sorry I have no answer for your program problem.
steve

Hi can anyone tell me the max weight reccomended for the arrow 1000
cheers
steve

Hi when you hit the transfer program button and then transfer program in
select the advanced tab to get the drip feed options.
steve

I think there is a setting for migrating tools on the a2100 this could be giving you problems.
Check the tool # against the pocket # and see if this corresponds to the tool being picked up. When my...

I am having problems with program sending using nclink from onecnc.
receiving is fine. large programs lose lines from the end small programs dont send at all and the control gives message no data to...

I am having similar problems with the A2100 when drip feeding but ok when transfering programs. I have been advised to use a shielded cable which i am having made at the moment. Have also been told...

hi does anyone have a gibscam post (pst file) for acramatic 2100