We drill a lot of these bars......
504034
.....and use an angle grinder to debur the ends to approx 6mm concave rad - does the job but not very consistent and a nasty job.
Looking at corner...
Type: Posts; User: cdspk
We drill a lot of these bars......
504034
.....and use an angle grinder to debur the ends to approx 6mm concave rad - does the job but not very consistent and a nasty job.
Looking at corner...
Hi, talking to a vintage car group who want to build a late 19th century, single cylinder engine based on very little other than a few photos and descriptions. They have a wealth of knowledge about...
Having a clear out, got 3!!! ancient Dell laptops with serial ports, was going to recycle them but wondered if anyone is still looking for them for old CNC kit? (One is a fancy M70 which I seem to...
New to Fanucs but I'm assuming that (when my boss finally gets his act together!) back up files to my PC will be accessible and editable by a simple text editor? Cheers,Sean
G76 internal thread clarification - 0i TB
Two line format
New to lathes
Got an external thread working fine, took a bit of playing but also got an internal going OK.
Want to clarify in more...
Hi Rouwdy, didn't get any answers to your thread but did you make any progress otherwise? I'm asking the same question as your thread with the same controller having only used (Heidenhain) mills...
In reality, to what accuracy can lathes commonly keep a long thread pitch length?
We have a 'dumbbell' shaped component - 28" long with a 5" long, 1 1/4" dia. 11tpi thread on each end.
The...
Just got the offline iTNC530 up and running but have stalled straight away as can't see how to create a new program - see attached image - looks like I need to have the .H extension but can't figure...