DEAR ALL,
WE HAVE ONE PINNACLE MACHINE HAVING MITSUBSHI CONTROLLER FCU64S.
AND HAVING SCREEN FCU6- DN22.
IN MORNING WHEN WE START THE MACHINE FCU6 -DN22 NOT SHOWING DISPLAY AND SEVEN SEGMENT...
Type: Posts; User: suresh patil
DEAR ALL,
WE HAVE ONE PINNACLE MACHINE HAVING MITSUBSHI CONTROLLER FCU64S.
AND HAVING SCREEN FCU6- DN22.
IN MORNING WHEN WE START THE MACHINE FCU6 -DN22 NOT SHOWING DISPLAY AND SEVEN SEGMENT...
thanks sir i found pallet return limit switch stucked
Respected friends,
We have doosan ACE-H100 machine .problem is that pallet arm advance means fetch the pallet after that required to arm return outside the door but it hang. so please suggest me...
please check overtravel limit switch & also working area limit parameters.
hello everyone
:rainfro:
We have Sinumrik 810t system having problem of plc,nc data loss because of
System Battery Down (Durra cell).
Battery Down problem comes frequently within 10 Days. so...
hi dear please go through following steps
1.if u have another fanuc system having dnc then you use same cable on ur fanuc 18-tb
2. otherwise make new cable like
25 pin at...
thanks Albert E
as per ur guidence i checked motor pulse coder and thermal sensor wire i found one wire RB from pulse coder disconnected after connecting it m/c working ok
thanks once again...
Dear all
We have one turning center having fanuc OT controller it shows message 2001 spindle fault,then i checked drive it shows alarm 01 - motor over heat so please help me how to solve this ...
for this problem press the data clear key and update the program data
these alarm meaning is 100% correct
first u check parameter code ISO/EIA,Baud rate set at lowest rate e.g 1200
then check cable connection 6,8,20 should be short at fanuc end ,check software handshek as well as hardware.
and check...
please check 6,8,20 pins should be short at fanuc end.
Dear Sir,
we have one turning center KWS500 of kiloskar& warner swessy having Fanuc OT controller many times it skipe M00 command so i want to confirm its system fault or any other.
i have one...