Search:

Sorry I'm kinda late to the party but here are some good videos to start off with. Check out this link.
Downloads

I have heid_conv.pst for V9. Fished it off of emastercam.com site years ago. Should be able to update it to X3.

Don't know much about Hass Controls but if you can use a thumb drive why not a USB hard drive. Same principal but more gigabytes per dollar.

Here's an attached DXF and NC file. See if it's something you can use, but remember, try it at your own risk!!

Sounds as if you want to translate yaxis to rotary over a known diameter.
If you have variables and math functions you can make a G code program.
What you need to know is the circumference of the...

Looking at your ISO program it doesn't look like your drilling on a tilted plane, but drilling in 5-axis. I believe the drill cycles only work when you define a work-plane. You'll probably have to...

Went through similar problems using a USB to SERIAL on a Heidenhain 426.
I bit the bullet and bought a PCMCIA to SERIAL card. Totally eliminated all my problems. If you've got an available PCMCIA...

DOS only recognizes a 2gb hard drive. If you had win95 setup and the hard drive was greater than 2gb it was using a FAT32 file system that DOS won't recognize. Load your DOS floppy and at a: prompt...

If you extracted the files from the large .zip file look for Pgmplatz_tast_en.pdf
That is a printable Acrobat PDF file of the PC keyboard overlay. I've used the 530 emulator and it works great!

I fished this post off the internet quite a while ago. It's the best one I've used for the 426/430 control in conversational. I also was an ISO code user. Believe me over time you'll see the...