Search:

yes. I exported all the files, the tools are all in metric an step.over it 30% to all tools.

No ideas? :(

I made a arduino pwm control.

In the preview it look ok... Only in reality is the problem...
Look in the picture to see the material left...

hi i got a problem with my cnc,
when i do a job with pocket with raster mode it dosent clear all the material after it makes the contur pass (the rest material it's inside the contur)...
the same...

hi,
i use the standard mach3 screen ( dont know how to change it)
How cand i use youre scipt for mai auto zero plate o Z?
i got olnly the auto zer tool button.
Thanks

hi, i have a problem.
I got the standard mach3 screen with no auto too zero setup, jut the button.
How can i make the same screen so i can use youre script?
I use a 1.4 mm thick plate.
Thanks!

Can someone please explain me for what is the decay and current stop on the board? What they do?

Hello, i bought this spindle
I got on my boad spindle output with 4 pins: CW, CCW GND and VSP.

The spindle controll board has GND and PWM input for mach3.
So...
on my board it says that the PWM...

found the problem...
the board has the Com pozitive and DIR, CP Negativ... that was the problem...
Now i can control the stepper, but with new problems...

When i press > the stepper spins a bit...

How can i chek if the stepper driver gets the signal from the board, if the driver gives the signal to the stepper...
Dont know what to do... Pls help

i found two methods one here
and one on YT here

but i dont know which one tot do.. or if it rezolv the problem... :(

Nobody? :(

Hello,
i'm whant to make a low cost CNC router, but i have some problems...
So here I go, I use these :

1. Break board- USB LPT Mach3 CNC 6 Axis Stepper Motor Controller Manual Control Box CNC...

Hi, my name is SIlviu I'm from romania and my hobby is electronics...
Now i'm working on a project that i started, a CNC 60cmx50cmx20cm, and I need some help with it...

So hope i can find the...