Haastec - they did level the entire machine to include the outriggers. Also, it's my understanding they lifted the entire bed off the ways just to make sure the ways were tight and there was nothing...
Type: Posts; User: MICFDI
Haastec - they did level the entire machine to include the outriggers. Also, it's my understanding they lifted the entire bed off the ways just to make sure the ways were tight and there was nothing...
No, we have not changed material distributors.
The sub-plate has been on and off numerous times in fact we have used different sub-plates with similar results. The HAAS tech's have even went so...
Although I read the CNC Forums, I seldom post. However, our shop has run into an issue I thought I would run by you folks. We purchased a HAAS VF-10 approximately 3 years ago. We haven’t had much...
Thank you for your time / help - much appreciated.
HAAS - VMC
3 axis stuff only.
I should have been a bit more clear on the problem.
If I am using X, Y, Z coordinates everything works fine. It is only when I change the work plane, do I experience the problem.
Esprit 2007
Anybody ever get an error "Can't reach this position (needs another axis of rotation)."
Work Coordinates are calling up the correct work planes and every thing seems to be fine...
The VF-10 has a problem with the holes in the auger system allowing to many chips into the coolant tank chip trap (we have to clean two times day). This wouldn't be a big problem as long as there...