Search:

I bet the mold shifted a little when the saddle was cast. Or, sometimes a company will make a casting from another casting, in which case tolerances can stack. I'd almost guarantee that Grizzly...

I'm a little late, I know, but I do see what caused some of your x-axis problems jarekp... If you look at the pics is post #7 and compare them to your pics 1 and 3 in post #8, you'll see that your...

That would work fine except the 5V power supply would have to be on all the time.

The way I have it now, I have my DC power supply connected to terminals 2 and 6 (with the motor). Circuit 13/14 is normally open (same as 43/44)(21/22 and 31/32 are NC). I think that I can connect...

Here are some pics of the contactor. I labeled the wiring diagram with the contactor terminal numbers(in blue). Also, pay no attention to the wires labeled L and N. They seem to be labeled...

Yes, I belive they are labeled A1 and A2. I'm just now beginning to understand this contactor.

Thanks for all your help. I found this, I think it will work...

If you don't mind another, probably stupid, question. I read that it needs to be installed across the coil...? I think that means...

The PLC I'm using is an ATMega328P-PU 28-pin DIP module. The power supply I made has the 100uF and 10uF caps on it. I even went as far as adding a 470uF cap just to see if it would help, and it...

First of all, hello, this is my first post here. Sorry it's so long, but it's a pretty specific question that, A: I'm not sure exactly how to ask, and B: haven't been successful in finding a good...