I have a Mazak Multiplex 630 with a Mazatrol t32-6 controller that is new to my shop. I am working on getting it up a going but I have run into an Alarm# 128 Emergency stop that I can't get rid of. ...
Type: Posts; User: Bullet605
I have a Mazak Multiplex 630 with a Mazatrol t32-6 controller that is new to my shop. I am working on getting it up a going but I have run into an Alarm# 128 Emergency stop that I can't get rid of. ...
Unfortunately neither Mazak or Mitsubishi had copies of the parameter disc. Mazak could go through the archives and find an original hard copy of the parameters, which I did have. So after a "hard...
I found the problem I was having entering the parameter. When entering as a decimal you need to use a mode of "0". I kept using a mode of "1" which the controller thought was a Hex input and causing...
Jim,
I'm having trouble when converting the negative decimal number to hex. After converting and entering into the M32 in hex format, it seems to come up with the wrong positive number. I tied...
Anyone know how to set the X Y coordinates of the tool measuring unit on a Mazak with Mazatrol M-32. My machine moves out into the middle of the table and moves -Z until it gets an alarm because it...
I have a M-32 controller on a Mazak V-515 that I am unable to upload any program to, from a PC. I have looked through other similar post and tried the different suggestions without any luck. I have...
Thanks Htech & onthebumper
I will give MEAU a call this afternoon to see what they can help me with. I did find in one of the manuals that came with my machine, the M-32 initialization and start...
I need help with a Mazak V515 with a Maxatrol M-32 controller that I recently acquired. Upon turning the NC power on I only get an orange screen and the controller does not boot up.
The machine...
Here is a link to a .pdf manual for a Richmill CNC300 that another user scanned and posted for me:
http://www.farmmap.co.nz/software/richmill.pdf
I am looking for a manual for a Richmill CNC30...
I am also looking for a manual for Richmill Cnc 30 indexer if anyone could come up with an extra copy
I would also be willing to pay for a copy
Did the machine have any downloading problems before the electrical storm or do you get any alarms? Is it a 3M controller? My Kitamura MyCenter 1 had a simular problem, I would try to up load a...