Search:

Its not the end mills, I measured the 1.7mm @ 1.7mm and the 6mm @ 5.99mm, and set them up correctly in aspire.

Nothing is loose, i have dial gauges at home on the x and y axis, and they read the same every time each axis is homed.
Also this morning i grabbed the x axis as it was doing all 10 moves from 0 to...

When I check the axis I looked at the distance at every 100mm , it was spot on
Also I am not a newbie, I have been using the machine for at least 2 years, just never checked if the parts were...

I set the steps with a 900mm rule, and calibrated it in mach3 and Uccnc, they are spot on

I have cut slots, like for a guitar fret board

Slots like this I I I I spaced apart 35.64, 33.64...

The cut is always out between .2 and .4 mm undersize

The steps have been set, there is no steps being dropped and no noticeable backlash, and the z axis is rock solid.
I set the steps with a...

Thanks Bob,

I am quite enjoying doing the videos, i wish i had done for the rebuild of my machine

https://www.youtube.com/watch?v=1USSmM5dqLY

https://www.youtube.com/watch?v=R7kBd6cRuSg
...

This is the first time I have done a video, which i must say is not very good.

However i always look on the bright side of things and maybe Chai at linearmotionbearings2008 will help me become a...

I have contacted him, and basically I
can send them back or he will refund me $40

The truth is he doesn't care, its almost my fault, how can it be like this, well the answer is Chai, your...

270528
every blue mark the screw head is too high
270532

270534

270530

not sure how else i can photograph these problems

have you calibrated the steps/inch on each axis?