Search:

forgot to add my setup is direct from g540 no switches etc

no beeping , response is good very similar to a normal vsd with a small ramp up set. videos and such not my thing and may be hard to get it to show op well but will have a crack at it when time...

gday all, just want to let yous know that i purchased , installed the lms spindle control board and after initially cooking the 110v transformer( using 240v) replaced it with a suitable one,...

gday 3space, sorry bout time taken to reply, been flat out no time for computer.. i didnt actually log my build as once again never enough hours in the day and no real need as i was basically...

gday 3space my solution was to remove all the electronics from the rear of mill and relocate them in a cabinet along with rest of my control gear. this way all well protected and access if required...

gday Graeme, noone has been able to get hold of promica for fair while! i dont run one of there machines but i do have a copy of the ica3 manual. if you pm me your email i will send it to you.

gday Neilw, glad to see your about, have read some dood info from your posts. i purchased a sx3 spindle speed upgrade kit from LMS. installed and wired as per instructions, powered up spindle started...

gday Jan just came accross this post. i know it's an old post but interested to know how you went with this project. success? cheers

not sure bout driving faster, think its more about torque needed to lift head. bummer is time takes to sort as ordered from there to here(slow turn around). do have a n23 381 supposecould mount that...

after testing wiring ,swapping axis over and checking settings am sure it is a faulty stepper. when can and if can work out how wil try post vid showing the random stalling/clunking that is...

no i am not running a gas but just happened to find one lying around the right size, so temp put on to see if helped-same issue occuring. so removed head to see how went without weight ,same- removed...

gday dogmeat spen time trying to sort out my z axis(gibb /dovetails) i followed cr recommendations if i have velocity anywhere over 700mm/min motor stalls. have wired it bipolar paralell. any...

cheers.got mine up and running again, still in setup process. have an issue with the z axis too. either slipping/stalling/alignment issue i have to look into.did you sort your z axis out. anything...

thanks dogmeat. which is exactly the 400 x 25.4. was running accurately on x,y. do you have the cr pulley on yours. set mine up via auto setup measureway. cant recall offtop what fig was think...

thank you for replying and sharing. are you using ball screws? on my x and y which are direct drive calculated step per unit is 400. can you please tell me your step per unit fig as thinking about...

gday all.first post. would liketo thank all the good people on this forum who use their time to share their knowledge and builds that inspire people such as myself to dive in and have a crack. just...